About 2 in 3 business jets sat in the harder quarter of their own type on at least one wear chapter. Our data shows 7,738 of the 11,540 jets we could grade on all four TailCheck chapters did so on fatigue, corrosion, engines and brakes, or utilization over the two years to November 2026. Which chapter it was changed from one jet to the next.
That spread is the reason a flight history report and a pre-purchase inspection do different jobs. The inspection looks at the aircraft and its records. A TailCheck report looks at how the aircraft was flown and where it sat, set against every other aircraft of its type. One tells a buyer what condition the jet is in. The other tells the buyer and the inspector where to look first.
What does a pre-purchase inspection cover?
A pre-purchase inspection is a physical and paper check of one aircraft, done by a maintenance shop the buyer picks. It has no fixed scope. AOPA's finance team puts it plainly: there is no universal standard for what a pre-buy must include, so the buyer and the shop agree the scope up front.
Most inspections are built from the same parts.
- Records review. The inspector reads the logbooks and maintenance records. Under 14 CFR 91.417(a)(2), the records kept for each aircraft include total time in service for the airframe and each engine, the status of life-limited parts, time since overhaul, current inspection status, airworthiness directive status and the Form 337 for each major alteration. Paragraph (b) says those records transfer with the aircraft when it is sold.
- Physical inspection. Technicians inspect the airframe, systems and interior, and run scheduled inspection tasks. Duncan Aviation describes its evaluations as logbook research plus function tests of high-failure components and a visual inspection of key areas.
- Engines. Bombardier's own pre-purchase examination lists a borescope inspection of both engines and of the APU, alongside scheduled airworthiness inspections and weight and balance, and sells it in tailored packages.
- Avionics and systems. FLYING's pre-buy guide lists tests of communication, navigation and other onboard systems, alongside the airframe, engine and records checks.
- Ground runs and a test flight. An AOPA Pilot article on turbine prebuys (Don Sebastian, October 2009) describes ground runs one engine at a time, then a flight test that records climb rates, engine temperatures and fuel flows against the book figures and checks pressurization and avionics in flight.
At the end, the buyer has a list of findings, the condition of the aircraft on the day and a view of whether the records are complete.
What does a flight history report cover?
TailCheck covers what the aircraft did between those records: how hard it was flown, where it spent its nights and what its departures asked of it. Every figure comes from flight tracking data and is placed among every tracked aircraft of the same type.
The report has four graded chapters, each taking the grade of one lead measure fixed in advance:
- Fatigue: estimated flight hours per landing, with the share of short hops under 300 nautical miles.
- Corrosion: nights within 2 km of the coast, with nights within 10 km, damp hours, freeze–thaw nights and moisture in the air.
- Engines and brakes: departures where the longest runway was under 1.25 times the type's takeoff distance, with hot, high takeoffs, density altitude at takeoff and nights in a dry climate.
- Utilization: flights a month, with days flown a month and estimated hours a year.
Each measure reads Typical inside the middle half of its type, between the 25th and 75th percentile. Outside that band it is graded as easier or harder on the aircraft than its type, depending on whether it eases or adds to that kind of wear. The report also shows, without a grade, tracking gaps, the longest stay away from its home field and the kind of place it sat, the spread of trip lengths, flights month by month and how this year compares with the same months last year. The sample report shows all of it for one G650.
How do the two compare?
The two answer different questions, so the table has few overlaps.
| Pre-purchase inspection | TailCheck flight history report | |
|---|---|---|
| What it looks at | The aircraft and its records, on the day | How the aircraft was flown and where it sat, over two years |
| Source | Hands-on inspection, logbooks, ground runs, test flight | Flight tracking data, airport and weather data |
| Compared with | The manufacturer's limits and the inspection program | Every tracked aircraft of the same type |
| Hours and landings | The logged totals | Estimated hours and tracked flights, as a minimum |
| Condition and airworthiness | Yes | No |
| Damage, corrosion, wear | Found where it is visible or tested | Exposure only: coastal and damp nights, short runways, hot and high takeoffs |
| Long stays on the ground | Explained by the records, if they are complete | Shown with dates by month and the kind of field |
| Who reads it | Buyer and inspector | Buyer and broker before inspection, then the inspector |
| When | Under a purchase agreement, near the end of a deal | Before choosing which aircraft to inspect |
The one row where they meet is hours and landings. The logbook total is the real figure. The tracked figure is a minimum, because tracking misses some flights, and the two should tell the same story.
Why does it matter where the inspector looks?
The harder end falls in different places on different jets. Among the jets we graded on all four chapters, about 1 in 4 sat in the harder quarter of the type on each of fatigue, corrosion, and engines and brakes. Utilization came out a little higher, at about a third.
Share of jets harsher than their type, by TailCheck chapter
- Utilization32.9%
- Corrosion25.1%
- Engines and brakes23.1%
- Fatigue22.8%
About 30 in 100 of those jets were in the harder quarter on two chapters or more. A third were in it on none. Two aircraft of the same type and age can have very different histories, and the flight history shows which chapters to raise with the inspector before anyone opens a panel.
Three of those measures show how often a buyer has something specific to point at.
How many jets lived by the sea?
About 1 in 5. In our flight tracking data, 2,688 of the 14,510 jets we could place spent at least half their nights at an airport within 10 km of the coast.
Salt air is a cause of corrosion, so a coastal history is something to tell the inspector. Our post on which private jets live by the sea covers the FAA's corrosion guidance and where it says corrosion usually starts. A coastal share measures exposure. Whether the aircraft was hangared, and what the inspection finds, decide what that exposure did.
How many jets had a long gap between flights?
More than half. Across the 19,372 jets with at least 20 tracked flights, 10,305 went 60 days or more between two tracked flights at least once in two years. About 31 in 100 went 90 days or more. Two years give more room for a long gap than one: over the 12 months to 1 November 2026, about 6 in 10 jets had a stretch of 30 days or more.
Share of jets whose longest gap between tracked flights reached each length
- 30 days or more87.2%
- 60 days or more53.2%
- 90 days or more31.1%
A gap is a question for the records. The aircraft may have sat in a shop, sat in storage or flown where tracking missed it. Each answer points the inspection somewhere different: the work package for a shop visit, the preservation records for storage, the logbook entries for flights we didn't see. TailCheck shows the longest stay away from base with the month and the kind of field, such as a manufacturer's service center for the type. It can't show what work was done there. For how long jets usually sit, see how often business jets sit idle, and for matching a logbook against a track, see how to verify aircraft logbooks against flight history.
How many large jets used short runways often?
About 2 in 5. Our data shows 2,934 of the 7,274 large-cabin jets we could rate made at least a quarter of their departures from fields whose longest runway was under 1.25 times the type's takeoff distance. For 1,136 of them, about 16 in 100, it was half their departures or more.
Jets with at least a quarter of departures from short runways, by size
- Large40.3%
- Medium15.5%
- Light3.4%
- Very light1.9%
Large jets need long runways, so more of the fields they use count as short for them. Hot, high departures are rarer. About 1 in 8 jets, 2,445 of the 19,195 we could assess, made at least 1 in 10 of its departures at a density altitude of 5,000 feet or more. A history of short, hot or high fields is worth telling the inspector, who can decide how much time the brakes, tires and engine records get.
How does a buyer use both?
TailCheck goes first, and the inspection goes last.
- Shortlist. Run each candidate tail and compare them side by side in Spotlight. A jet graded hard on utilization and corrosion and one typical on everything are different purchases, even at the same age.
- Ask for the records. Use the report's gaps and long stays to ask the seller for the matching logbook entries and work orders before any inspection is booked.
- Scope the inspection. Give the inspector the report. Coastal and damp nights point to corrosion-prone areas. Short-runway and hot, high departures point to brakes, tires and engine records. A long stay at a service center points to that work package.
- Reconcile. Check the logged hours and landings against the tracked figures. They should agree, with the logbook at or above the tracked figures.
The FAA rule on records sets which records go with the aircraft when it is sold. The flight history shows which pages of it a buyer should read most closely.
The type's fleet page carries live figures for the measures behind two of the chapters. For the G650 in the sample report:
447 G650s with enough flights to measure, 1 Nov 2025 – 31 Oct 2026, from the same fleet data as every page. The middle half runs from the 25th to the 75th percentile.
The fleet page works over the latest 12 full months, so its figures can differ a little from the two-year grades in a report.
What should a buyer check?
- Run the tail before the inspection. Find out which chapters sit outside the middle half of the type, and which way.
- Compare candidates against their own type. A G650 is graded against G650s and a Phenom 300 against Phenom 300s.
- Match every long gap to the records. Ask what happened in each stay away from base and each tracking gap of a month or more.
- Ask about the hangar. Tracking can't see inside one, and it changes what a coastal history means.
- Hand the report to the inspector. Name the chapters graded harder than the type so the inspection spends its time there.
- Reconcile hours and landings. Logged totals should be at or above the tracked ones.
- Inspect every aircraft you buy. The report shortens the list and aims the inspection. It doesn't replace the inspection or the records review.
A TailCheck report grades one aircraft against its type across fatigue, corrosion, engines and brakes, and utilization. The sample report shows every chapter, and you can check a tail for free first. Spotlight compares several candidates at once, and the buyer's guides for types such as the G650, Phenom 300 and Challenger 300 cover each type's figures and how its fleet flew.
How we measured this
- Chapter grades: 11,540 business jets graded on all four chapters against all tracked aircraft of their type (types with at least 30 aircraft), every region, two years to November 2026 (utilization and fatigue to 19 November, corrosion and engines and brakes to mid-November). Harder means beyond the 75th percentile of the type on the chapter's lead measure, and on the harder side of the type's median. For fatigue that is fewer estimated hours per landing.
- Coastal nights: 14,510 jets we could place on at least a quarter of their nights. A night is placed when the aircraft left from the airport it last landed at. Coast distance is from the airport's reference point to the OpenStreetMap coastline (© OpenStreetMap contributors).
- Gaps: 19,372 jets with at least 20 tracked flights, two years to 19 November 2026. The longest gap counts calendar days between consecutive days with a tracked flight, so it can include flights tracking missed. Fleet-wide outage days in the flight data last three days at most, too short to create gaps of this length.
- Short runways: 17,421 jets with at least 20 departures where both the runway and the type's takeoff distance are known. We use each field's longest runway. Size classes follow our aircraft specification table.
- Hot and high: 19,195 jets with at least 20 departures assessed, covering most of their departures. Density altitude comes from ERA5-Land reanalysis weather (Copernicus Climate Change Service) for the hour of departure, adjusted for field height.
- Hours are estimated from time in the air. Our methodology explains how flights are detected.
- Outside sources: 14 CFR 91.417 from the eCFR; AOPA's finance team and AOPA Pilot on pre-buy scope and turbine prebuys; Bombardier and Duncan Aviation on what their pre-purchase examinations include; FLYING on the systems checks in a pre-buy.
Sources
- Aircraft Ledger flight data. Methodology
- Aircraft type: Gulfstream G650/G650ER
- Aircraft type: Embraer Phenom 300
- Aircraft type: Bombardier Challenger 300/350
First published .